There is no need to disconnect the battery, ever. It’s super small, and the best part is that you can hook a LiPo battery up to it, with the ability to charge it through the USB connector on the board. An Adafruit Feather 32U4 Bluefruit LE, which is an Arduino compatible, BLE capable board. I would download a copy, in case it ever becomes worth something, some day. Using the code I wrote back then, and visual inspection of the finished product, I’ve made a drawing of how the different components are connected, using state of the art graphics software. I would’ve loved to show you how I wired it up in steps, but this was all done 2 years ago and it didn’t occur to me then to make photos along the way. I didn’t use the wires in my one, but perhaps it could be useful for something. I tried to save the wires of the doodad on the right-hand side, but failed and ended up cutting them off with the Dremel. I am sure you could use a very sharp knife, but the plastic is pretty strong, so you may end up cutting your way into the hospital emergency department. I used a marker to draw out what I was going to cut. Next, go to town on the cover with a Dremel, removing all the excess plastic. Desolder or cut them away from the board. The wires to the motors are attached to a small PCB, which you can see once you’ve opened it up. It takes a single screw to remove the lid, to get to the batteries and then another 3 to remove the top of the robot. Direction is changed by rotating the main body, using a second motor, which changes the disposition of the legs, changing the direction in which the entire robot moves. All the 6 legs are powered with a single motors. These Battle Spiders are mechanically really interesting. Ever since I saw these HEXBUG Battle Spiders, I’ve wanted to tear them apart and supply them with a more capable brain. This is a project I’ve had on the shelf for quite some time (2 years or so), and only just now finished up.

Download hex bug battle ground